#Kanso 2 user guide software#

#Kanso 2 user guide software#

If you use a Software pad and experience intermittent sound from your processor, try removing the Softwear pad.If your sound processor does get wet, dry it with a soft dry cloth and place it in your Home Charger for at least eight hours.If your Aqua+ appears damaged or worn, replace it with a new one.Avoid pressing with your fingernails as this can damage Aqua+.If the seal is ok, separate the two halves again and place your Aqua+ in your storage case or the Kanso 2 Activity Kit’s waterproof case until you want to use it again.If any air leaks out you should not use it again. Put the two halves together and test the seal by pressing down gently on the cover.Check that the Aqua+ is thoroughly dry.Open the Aqua+ cover and remove your sound processor.Rinse Aqua+ with clean water and dry with a soft cloth.Place the clip on your clothing and press down on the lever to close the clip.Create a knot by passing the clip through the line loop.Thread the loop end of the line through the hole in the Aqua+.Retention lines longer than the Safety Line (short length) are not recommended for use by children under 3 years as they may present a risk of strangulation. Remember, you can’t go deeper than 3 meters. Finally, do the Aqua+ for Kanso 2 Checklist to make sure you’re ready!.Make sure your sound processor is still in the correct position on your implant. To keep Aqua+ on your implant, use a retention aid such as goggles.

Place the Aqua+ on your implant as normal, making sure the Cochlear logo, light, and microphone ports are facing up.

If you’re worried about losing Aqua+, use a Nucleus Safety Line to attach it to your clothing.

Make sure your Aqua+ is properly sealed, so water doesn’t leak in and damage your processor.

Press firmly around the edges until the base is flush with the cover.

This could affect sound quality and comfort. Make sure you don’t trap too much air in the cover. After the lock parts are fitted, lower the other end of the cover onto the base.

Align the lock on the cover and base and fit them together.

If you use a Cochlear SoftWear™ pad, you can leave it on the processor.Your Aqua+ is shaped so your processor only fits one way.Place your sound processor in the Aqua+ base with the Cochlear logo, light, and microphones facing up.If it is damaged, use a new Aqua+.Īnything that affects the seal may cause water to leak in and damage your sound processor. Put your thumb under the cover tab and push upwards.ĭon’t damage the cover with your fingernails. Place your thumbnail in the slot at the base and lift. Remove it from your sound processor if you use a Kanso 2 Safety Line.